descargar manual lavadora blue sky blf 1009 angel

Remove the three screws that hold the door latch assembly in place. There is a small wire clamp holding it in place. You will also have to remove the door boot from the fill tube on the left hand side of the door opening. Pull the rubber boot from the frame and push it inside towards the wash tub. Gently pry this spring apart and pull the wire hoop from the groove. Follow this hoop around to the bottom of the door opening and locate the wire tension spring. It is located behind the rubber seam where it attaches to the door frame. Verizon skate CDMA routing while T-Moble monographs GSM. Locate the wire hoop retainer around the rubber door boot.ĭownloadDescargar manual lavadora bluesky blf 1009. You can leave the wires attached and simply lay the console across the top of the washer out of the way. Use care not to pull or damage any of the wiring. If you push in slightly while pulling outwards the panel pops off. Take a putty knife and insert it under the console seam right above the door. Remove the operator console by removing the dispenser and the scew(s) behind it. The panel should slide back, and then lift off.

Remove the washer top panel by removing the three torx-type screws (or 7mm) where it attaches in the rear of the washer. A replacement bellow isn't cheap (prices vary, but are around $75-80), so hopefully these helpful steps will eliminate the need to call a repair service and pay the additional labor charges.

15935 Answers SOURCE: A lot of concerns have been raised about door bellows molding, mildewing, and/or ripping and needing replaced.

› ▲ Descargar Manual Lavadora Bluesky Blf 10098199964

Descargar manual lavadora blue sky blf 1009 angel